![]() ![]() Locate these holes and remove the screws that are currently in place. Your vehicle should have holes factory drilled into the wheel well for these mud flaps to work. ![]() Test that the flaps will work for your vehicle by holding them up and comparing them to the shape and fit of the space available and check for a “RH” or “LH” mark for proper placement. Turn the front wheels to the left fully for the most clearance between the tire and wheel well. ![]() Step 2: Create space between the tire and wheel well. Clean the area where the mud flaps will be installed. While it is recommended to follow the instructions for your specific make and model of mud flap, general steps for installing a “no-drill” mud flaps are as follows: Installing mud flaps can commonly can be done in one of two ways, either “no-drill” or requiring a drill for some necessary bolt holes. Part 1 of 2: Installing "no-drill" mud flaps on a car Slightly different than spray guard, a mud flap is a longer, wider device commonly made of rubber or composites that can be used on any type of vehicle. Mud flaps or mud guards can be used to minimize the amount of spray, or water, that a car, truck, or SUV produces while driving in wet, muddy, or rainy conditions. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |